web analytics

PassLeader 300-360 Exam Dumps Collection with VCE and PDF (Question 31 – Question 35)

New 300-360 exam questions from PassLeader 300-360 dumps! Welcome to download the newest PassLeader 300-360 VCE and PDF dumps: http://www.passleader.com/300-360.html (185 Q&As –> 208 Q&As –> 230 Q&As –> 262 Q&As)

P.S. Free 300-360 dumps are available on Google Drive shared by PassLeader: https://drive.google.com/open?id=0B-ob6L_QjGLpWVVreDl3bGRhakk

QUESTION 31
After the completion of a site survey with Ekahau Site Survey tool, using the default color palette, it is noted that multiple areas are shown as white on the heat map when viewing 5 GHz signal strength data. What does this indicate about the signal strength?

A.    The area is below the minimum threshold configured on the tool.
B.    The area is below the detectable level and indicates no RF signal.
C.    The area is below -100 dBm at coverage cell edge.
D.    The area is below -67 dBm at coverage cell edge.

Answer: A

QUESTION 32
An engineer must design wireless coverage in thick-walled stairwells. Which information should the engineer refer to when determining where APs can be installed?

A.    Local or National Building Code
B.    IEEE
C.    BICSI TDMM
D.    Cisco Hardware Installation Guide

Answer: D

QUESTION 33
An engineer is performing a predictive wireless design for a medical treatment environment, which requires data and voice services. Which of the following is a requirement for the design?

A.    overlapping -72 dBm coverage from two access points
B.    overlapping -67 dBm coverage from two access points
C.    continuous -67 dBm coverage from one access point
D.    continuous -72 dBm coverage from one access point

Answer: C

QUESTION 34
A network engineer is preparing for an office site survey with a height of 2.5 meters. Which three components are recommended to complete the survey? (Choose three.)

A.    Use APs with external antennas.
B.    Use DoS attack on APs while measuring the throughput.
C.    Use APs with built-in antennas.
D.    Use a battery pack to power APs.
E.    Use a drawing of the office space to draw AP and client placements.
F.    Use APs with directional antennas.

Answer: CDE

QUESTION 35
An engineer is planning for a 24 Mbps data rate for a new installation. What is the coverage area from the AP if the environment and other factors are not taken into consideration?

A.    225 feet
B.    80 feet
C.    150 feet
D.    100 feet

Answer: A


New 300-360 exam questions from PassLeader 300-360 dumps! Welcome to download the newest PassLeader 300-360 VCE and PDF dumps: http://www.passleader.com/300-360.html (185 Q&As –> 208 Q&As –> 230 Q&As –> 262 Q&As)

P.S. Free 300-360 dumps are available on Google Drive shared by PassLeader: https://drive.google.com/open?id=0B-ob6L_QjGLpWVVreDl3bGRhakk