New 2020 CCIE/CCNP 350-401 ENCOR exam questions from PassLeader 350-401 dumps! Welcome to download the newest PassLeader 350-401 VCE and PDF dumps: https://www.passleader.com/350-401.html (770 Q&As –> 793 Q&As –> 822 Q&As –> 992 Q&As –> 1025 Q&As –> 1129 Q&As –> 1198 Q&As –> 1239 Q&As) [Lab Simulations Available]
P.S. Free 2020 CCIE/CCNP 350-401 ENCOR dumps are available on Google Drive shared by PassLeader: https://drive.google.com/open?id=1nv6C6Az-yuR5kOXg8FV3gytDer_usQBX
NEW QUESTION 746
What is one benefit of adopting a data modeling language?
A. augmenting management process using vendor centric actions around models
B. refactoring vendor and platform specific configurations with widely compatible configurations
C. augmenting the use of management protocols like SNMP for status subscriptions
D. deploying machine-friendly codes to manage a high number of devices
Answer: B
NEW QUESTION 747
Which option must be used to support a WLC with an IPv6 management address and 100 Cisco Aironet 2800 Series access points that will use DHCP to register?
A. 43
B. 52
C. 60
D. 82
Answer: B
NEW QUESTION 748
An engineer is configuring Local WebAuth on a Cisco Wireless LAN Controller. According to RFC 5737, which virtual IP address must be used in this configuration?
A. 192.0.2.1
B. 172.20.10.1
C. 1.1.1.1
D. 192.168.0.1
Answer: A
NEW QUESTION 749
By default, which virtual MAC address does HSRP group 32 use?
A. 00:5e:0c:07:ac:20
B. 04:18:20:83:2e:32
C. 05:5e:5c:ac:0c:32
D. 00:00:0c:07:ac:20
Answer: D
NEW QUESTION 750
What does the number in an NTP stratum level represent?
A. The number of hops it takes to reach the master time server.
B. The number of hops it takes to reach the authoritative time source.
C. The amount of offset between the device clock and true time.
D. The amount of drift between the device clock and true time.
Answer: B
NEW QUESTION 751
How does SSO work with HSRP to minimize network disruptions?
A. It enables HSRP to elect another switch in the group as the active HSRP switch.
B. It ensures fast failover in the case of link failure.
C. It enables data forwarding along known routes following a switchover, white the routing protocol reconverges.
D. It enables HSRP to failover to the standby RP on the same device.
Answer: D
NEW QUESTION 752
What is one characteristic of VXLAN?
A. It supports a maximum of 4096 VLANs.
B. It supports multitenant segments.
C. It uses STP to prevent loops in the underlay network.
D. It uses the Layer 2 header to transfer packets through the network underlay.
Answer: B
NEW QUESTION 753
In which two ways does the routing protocol OSPF differ from EIGRP? (Choose two.)
A. OSPF supports an unlimited number of hops. EIGRP supports a maximum of 255 hops.
B. OSPF provides shorter convergence time than EIGRP.
C. OSPF is distance vector protocol. EIGRP is a link-state protocol.
D. OSPF supports only equal-cost load balancing. EIGRP supports unequal-cost load balancing.
E. OSPF supports unequal-cost load balancing. EIGRP supports only equal-cost load balancing.
Answer: AD
NEW QUESTION 754
Which tool is used in Cisco DNA Center to build generic configurations that are able to be applied on device with similar network settings?
A. Command Runner
B. Template Editor
C. Application Policies
D. Authentication Template
Answer: B
NEW QUESTION 755
Which router is elected the IGMP Querier when more than one router is in the same LAN segment?
A. The router with the shortest uptime.
B. The router with the lowest IP address.
C. The router with the highest IP address.
D. The router with the longest uptime.
Answer: B
NEW QUESTION 756
An engineer must configure a new WLAN that allows a user to enter a passphrase and provides forward secrecy as a security measure. Which Layer 2 WLAN configuration is required on the Cisco WLC?
A. WPA2 Personal
B. WPA3 Enterprise
C. WPA3 Personal
D. WPA2 Enterprise
Answer: C
NEW QUESTION 757
A customer wants to connect a device to an autonomous Cisco AP configured as a WGB. The WGB is configured properly: however, it fails to associate to a CAPWAP-enabled AP. Which change must be applied in the advanced WLAN settings to resolve this issue?
A. Enable Aironet IE.
B. Enable passive client.
C. Disable AAA override.
D. Disable FlexConnect local switching.
Answer: A
NEW QUESTION 758
An engineer is describing QoS to a client. Which two facts apply to traffic policing? (Choose two.)
A. Policing adapts to network congestion by queuing excess traffic.
B. Policing should be performed as close to the destination as possible.
C. Policing drops traffic that exceeds the defined rate.
D. Policing typically delays the traffic, rather than drops it.
E. Policing should be performed as close to the source as possible.
Answer: CE
NEW QUESTION 759
A network administrator is preparing a Python scrip to configure a Cisco IOS XE-based device on the network. The administrator is worried that colleagues will make changes to the device while the script is running. Which operation of he in client manager prevent colleague making changes to the device while the scrip is running?
A. m.lock(config=’running’)
B. m.lock(target=’running’)
C. m.freeze(target=’running’)
D. m.freeze(config=’running’)
Answer: B
NEW QUESTION 760
In a Cisco SD-Access fabric, which control plane protocol is used for mapping and resolving endpoints?
A. DHCP
B. VXLAN
C. SXP
D. LISP
Answer: D
NEW QUESTION 761
Which function does a Cisco SD-Access extended node perform?
A. provides fabric extension to nonfabric devices through remote registration and configuration
B. performs tunneling between fabric and nonfabric devices to route traffic over unknown networks
C. used to extend the fabric connecting to downstream nonfabric enabled Layer 2 switches
D. in charge of establishing Layer 3 adjacencies with nonfabric unmanaged node
Answer: C
NEW QUESTION 762
What is the function of vBond in a Cisco SD-WAN deployment?
A. initiating connections with SD-WAN routers automatically
B. pushing of configuration toward SD-WAN routers
C. onboarding of SD-WAN routers into the SD-WAN overlay
D. gathering telemetry data from SD-WAN routers
Answer: C
NEW QUESTION 763
When using BFD in a network design, which consideration must be made?
A. BFD is used with first hop routing protocols to provide subsecond convergence.
B. BFD is more CPU-intensive than using reduced hold timers with routing protocols.
C. BFD is used with dynamic routing protocols to provide subsecond convergence.
D. BFD is used with NSF and graceful to provide subsecond convergence.
Answer: C
NEW QUESTION 764
Drag and Drop
Drag and drop the characteristics from the left onto the switching mechanisms they describe on the right.
NEW QUESTION 765
Drag and Drop
An engineer must create a script to append and modify device entries in a JSON-formatted file. The script must work as follows:
– Until interrupted from the keyboard, the script reads in the hostname of a device, its management IP address, operating system type, and CLI remote access protocol.
– After being interrupted, the script displays the entered entries and adds them to the JSON-formatted file, replacing existing entries whose hostname matches.
The contents of the JSON-formatted file are as follows:
Drag and drop the statements onto the blanks within the code to complete the script. Not all options are used.
NEW QUESTION 766
……
New 2020 CCIE/CCNP 350-401 ENCOR exam questions from PassLeader 350-401 dumps! Welcome to download the newest PassLeader 350-401 VCE and PDF dumps: https://www.passleader.com/350-401.html (770 Q&As –> 793 Q&As –> 822 Q&As –> 992 Q&As –> 1025 Q&As –> 1129 Q&As –> 1198 Q&As –> 1239 Q&As) [Lab Simulations Available]
P.S. Free 2020 CCIE/CCNP 350-401 ENCOR dumps are available on Google Drive shared by PassLeader: https://drive.google.com/open?id=1nv6C6Az-yuR5kOXg8FV3gytDer_usQBX